Commodore A 2091-40 - 3.2.4 Installing Your Language Specific Workbench; 3.2.5 Quick Installation

Installing the A2091-40/A2091 e 3-19
1. Boot your system with the A2091 Installation Software disk in the floppy drive.
2. Double-click on the A2091 Installation Software icon.
3. Double-click on the HDToolbox icon.
4. When the Hard Drive Preparation, Partitioning and Formatting screen
appears, click on Verify Data on Drive. When prompted by the requestor, click
on Continue. If the verification finds no errors, you can click on Exit and continue
normally. If any new errors are found you should Exit and then run PrepHD and
FormatHD as described under Using the Installation Software on page 5-2.
3.2.4 Installing Your Language Specific Workbench
If you wish, you can install your language specific Workbench by running InstallHD
and inserting Workbench and Extras at the request. This will automatically change
the keymap.
If your system failed to boot from the hard disk, and the A2091-40 is connected
properly, run the following Quick Installation Procedure:
3.2.5 Quick Installation
It your system cannot find the hard disk supplied with the A2091-40, and you have
connected it correctly, the disk may have lost some data during shipment. You may
need to prepare it following the steps below. Note that this procedure will only work
with a Quantum ProDrive 40S SCS! hard disk. Do not run PrepHD or FormatHD
on any other type of hard disk. Please refer to the section Running the Installation
Software for more information.
1. Boot your system with the A2091 Installation Software disk. Do not boot from
the hard disk.
Double-click on the A2091 Installation Software icon.
Double-click on the PrepHD icon, and follow the instructions on the screen.
When PrepHD has finished, reboot the system.
Double-click on FormatHD and follow the instructions on the screen.
Insert Workbench and Extras when requested by the system.
N 2? n ABN
Your hard disk is ready for use.