Commodore A 2091-40 - Software Installation Procedure

Installing the A2091-40/A2091 _ 317
1 0. Replace the Amiga's Cover
Replace the Amiga's cover. Reconnect all cables and peripherals to the computer.
Tum the power on to the Amiga 2000.
A2091-40 users can affix the Amiga 2000HD label to the front of your Amiga. Peel
off the Amiga 2000 label. Remove the adhesive backing from the Amiga 2000HD
label and affix it to the cover.
The hard disk supplied with the A2091-40 is already formatted, and has Workbench
and Extras installed on it. If you have Kickstart 1.3 installed in your Amiga, and the
autoboot ROMs are enabled, you can boot directly from the hard disk.
If you are running Kickstart 1.2 you will need to create a boot floppy disk as described
on page 3-18, Kickstart 1.2 Users.
if you have installed an A2091-40 you will need to verify the contents of the hard
disk by following the procedure on page 3-18, Verifying the A2091-40,
If you are installing any other hard disk, refer to Preparing a New Hard Disk on
page 3-20.
if you wish to install your language specific Workbench, follow the procedure on
page 3-19, Installing Your Language Specific Workbench.
3.2 Software Installation Procedure
3.2.1 Kickstart 1.3 Users
M you have Kickstart 1.3 installed in your machine, and have enabled the ROMs
on the A2091, you can boot your system directly from the hard disk, When you start
your system, the hard disk will automatically boot, If you wish you may still boot
from the floppy drive, rather than from the hard disk, by placing a bootable disk in
the floppy drive at start-up. Verify the contents of the hard disk as described in
Verifying the A2091-40 on the next page.