Commodore A 2091-40 - Transferring a Hard Disk from an A2090

Installing the A2091-40/A2091 3-21
12. A new icon will appear for each partition on the hard disk. The icon name will
appear in the form: devicename:xxxx. The devicename ends in a number that
may include a decimal paint. Perform the following procedure on the icon with
the lowest number in the name:
a. Click on that icon and select Initialize from the Workbench menu,
b. When the Initialize is complete, select Rename from the Workbench menu
and change the name of the partition.
c. Copy Workbench and Extras to the partition by clicking on InstallHD, then
hold down the key and double-click on the partition's icon.
13. Perform steps 12a and 12b on the other new partition icons.
14. Your hard disk is now ready for use.
3.2.7 Transferring a Hard Disk From an A2090
In order to transter a SCSI hard disk from an A2090 to an A2091, after making a
backup of the contents and physically installing the hard disk, follow the steps below:
1. Reboot your system with the A2091 Installation Software disk.
Double-click on the A2091 Installation Software disk icon.
Double click on the HDToolbox icon,
2.
3.
4. Click on Partition Drive.
5. Click on Advanced Options.
6.
Set each partition's starting and ending cylinders so that they match the
information recorded in your mountlist,
7.
Set
each
partition
name
to
match
the
partition
names
from
the
A2090.
8.
Click
on
OK.
9. Click on Save Changes to Drive.
10. Click on Exit.
11. Reboot your system. Your hard disk is now ready for use,