57ENGLISH
Starting up the robot vacuum cleaner
Setting the time
1. Point the remote control at the switched-on robot vacuum
cleaner.
2. Hold down the
button on the remote control for approx. 2
seconds until the hour display ashes.
3. Use the
and buttons to select the current time. Use the
and buttons to switch between minutes and hours.
4. Press the
button to save the
stored time.
NOTE!
• The robot vacuum cleaner conrms that the time has been
saved by emitting an acoustic signal.
• To connect the remote control to the robot vacuum cleaner,
proceed as follows:
1. Press the
button for about 5 seconds.
2. While the connection is being established, "8888" will be
shown on the display of the remote control.
3. As soon as the connection has been established, the
time will be displayed again.
• If the connection attempt fails for 30 seconds, the display will
continue to show "8888".
• Make sure that the robot vacuum cleaner is switched on
before you try to pair it with the remote control.
To Next Page
Loading...