56 ENGLISH
Starting up the robot vacuum cleaner
Preparing the remote control
To operate the remote control, you will need 2 x 1.5 V AAA bat
-
teries (not included in the scope of delivery).
1. Open and remove the battery compartment lid on the back of
the remote controller.
2. Place 2 x 1.5 V AAA batteries into the battery compartment.
Ensure the polarity is correct.
3. Replace the battery compartment lid.
If the remote control will not be used for a long time, remove the
batteries.
Status display
You can see the current status of the robot vacuum cleaner by
pressing the power button
:
The button will light up in
white
Robot vacuum cleaner in operation
Button slowly pulses in
yellow
The battery is charging
Button ashes in yellow
The battery is low/
the robot vacuum cleaner is returning to
the charging station
Button ashes in white Network conguration mode is active
Button slowly pulses in white
Robot vacuum cleaner is starting up/
rmware is updating
Button ashes in red Fault
To Next Page
Loading...