4. Commissioning
MF0150A9A_prel.docx Manual for ION-M23 SDARS 3-Sector Page 27
8. Clean in the similar way the
connector of the connected cable.
Remove protective caps from the
unit connector first.
9. Remove metal chips and small
particles from the mating and inner
surfaces of the connector using
compressed air.
10. Continue with the winding area
using lint-free wipe drenched with
isopropyl alcohol.
11. Continue with the inside mating
surface of the inner ring.
12. Clean the outside surface of the
center pin.
To Next Page
Loading...
