Troubleshoong
CAUTION! If required, you can reset the AP to its factory default
sengs by pressing the reset buon located inside the PoE IN port. Use
the p of a pen or a 3-mm at-blade screwdriver to press the reset
buon. Press and hold the reset buon for 4 seconds or longer to
restore to factory defaults. DO NOT RESET THE AP TO FACTORY DEFAULT
SETTINGS UNLESS SO INSTRUCTED. (Doing this resets the AP IP address
to 192.168.0.1.)
NOTE: Aer a reset, you can access the internal AP web interface using
hps://192.168.0.1. Your device must use any other address from
192.168.0.2 through 192.168.0.254, with subnet mask 255.255.255.0.
The username is super, and the password is sp-admin. Refer to the
Outdoor Access Point User Guide for informaon on conguring and
operang the AP. This document is available at hps://
support.ruckuswireless.com.
©
2021 CommScope, Inc. All rights reserved.
ARRIS, the ARRIS logo, COMMSCOPE, RUCKUS, RUCKUS WIRELESS, the Ruckus
logo, and the Big Dog design are trademarks of CommScope, Inc. and/or its
aliates. Wi-Fi Alliance, Wi-Fi, the Wi-Fi logo, Wi-Fi Cered, the Wi-Fi
CERTIFIED logo, Wi-Fi Protected Access, the Wi-Fi Protected Setup logo, Wi-Fi
Protected Setup, Wi-Fi Mulmedia and WPA2 and WMM are trademarks or
registered trademarks of Wi-Fi Alliance. All other trademarks are the property of
their respecve owners.
Copyright
©
2021 CommScope, Inc. All rights reserved. Page 4 of 4
Published September 2021, Part Number 800-72904-001 Rev A