CommScope ValuLine VHLP3 Series - Pole Mounting and Elevation; Pole Diameter and Support Check; Elevation Adjustment Guide

G4
galv
38Nm
5%
90-120mm Pole
Secure assembled mount to pole ensuring
clamp bolts are seated correctly.
This mount can only be used
for pole diameters from 90-120 mm
Pole to be structural engineer
approved rigid structural support
SLING
2
Elevation
adjustment nut
1
Loosen ½ turn,
do not remove.
1
Loosen ½ turn,
do not remove.
1
Loosen ½ turn,
do not remove.
Elevation adjustment
Loosen 3 screws (1).
Adjust elevation by bolt head (2).
On completion tighten screws (1) to
38Nm ± 5%
Adjustment Range ±15°
Page 18 of 20
7706805
MOUNT ATTACHMENT AND ALIGNMENT
SECTION 7 INSTALLATION
INSTRUCTIONS
NEVER WALK
UNDER HOISTED
LOADS