To Next PageTo Next Page
Need help?Do you have a question about the CommScope ValuLine VHLP3 Series and is the answer not in the manual?
General| Lightning Protection | dc Ground |
|---|---|
| Downtilt | 0° |
| Impedance | 50 ohm |
| Storage Temperature | -40°C to +70°C |
| Humidity | Up to 100% |
| Operating Temperature | -40°C to +60°C (-40°F to +140°F) |
Read this manual fully before unpacking and assembling the antenna.
Antenna installation, maintenance, or removal must be performed by a qualified experienced installer.
Do not use installation components other than those supplied or recommended.
This instruction describes how to assemble a VHLP(X)3 antenna.
Follow national and local safety regulations to avoid injury and property damage.
Installation and service must be carried out by authorized personnel with appropriate training.
Use local safety regulations where mandatory; manual instructions supplement local rules.
Use only supplied or recommended installation components and protective wear.
Follow procedures, use correct tools, safety devices, and ensure all hardware is tightened correctly.
Antenna systems should be inspected annually by qualified personnel.
Use tested equipment, trained personnel, specified points, and follow regulations.
Be aware of risks from falling or falling objects in work areas.
Details of the equipment and tools supplied in the kit, including part numbers.
List of required tools with thread and diameter specifications for fasteners.
Visual representation of the various antenna components and hardware kits.
Handle reflector and radome with care, avoid excessive weight, and place on flat ground.
Instructions for attaching the feed assembly for 6, 7, and 11 GHz frequencies.
Instructions for attaching the feed assembly for 13 to 38 GHz frequencies.
Detailed steps for assembling the mount components and attaching to the antenna.
Specific torque values for mount fasteners (G5, G6) to ensure secure attachment.
This mount is for 90-120mm poles; ensure structural engineer approval for support.
Steps to adjust antenna elevation within a ±15° range using specific screws and bolt heads.
Instructions for adjusting azimuth (pan left/right) and tightening screws G1 and G2 to specified torques.
Antenna designed for minimal maintenance; regular inspection ensures trouble-free operation.
If cleaning is required, solvent-based solutions must not be used.
