Configuring your Mariner X2
Page 18
7. Set the baud rates to the required level for each of the serial
ports.
• Set the RS232 baud rate to the required level. The default is
38,4
00. This is the baud rate used when communicating with a
PC via the RS232 connection.
• Set the NMEA output (transmit) baud rate to the required level.
The default is 38,400. This is the baud rate used when
transmitting data to a chart plotter via its NMEA0183 input.
• Set the NMEA input (receive) baud rate to the required level.
The default is 4,800. If you are using an optional NMEA0183
device such as a heading sensor (see section 3.2) please select
the baud rate at which the NMEA0183 device is transmitting
dat
a. If you are not using an optional NMEA0183 device this
baud rate should be set to the same level as the NMEA transmit
baud rate.
7. Once all data has been entered correctly, press 'Save static data
to
AIS unit'. This will permanently store the data to the unit.
8. You will see a pop-up window warning you that the MMSI can
on
ly be entered once and should therefore be entered correctly.
Please double check you have entered the correct MMSI.
9. All other static data can be modified by repeating the steps
ab
ove.
10. If you need to change the MMSI for any reason please contact
y
our dealer who will be able to reset the unit.
To Next Page
Loading...