1. Make sure that the dispenser is idle, with the nozzle in its holster.
2. Press and release the K-Factor switch until the required pressure
reading is shown (u, uA, ub, uA2 or ub2 )
3. Enter in the new pressure.
Each press of the K-Factor switch passes you over a
digit in a setting, making the digit blink. Holding the switch down for
more than a second changes whichever digit is currently displayed. If
you want to pass over a setting without changing any digits, keep
pressing and releasing the switch.
Let the menu time out so that the value and quantity amounts are
displayed.
To Next Page
Loading...