Compak E5 OD - Page 23

ORIGINAL INSTRUCTIONS | Ref. quality process 002/03 | v. 12/07/2016 | K06307
22
Following these steps will ensure that the grinder is clean and ready for use.
We do not recommend the taking apart of the grind assembly unless changing burrs,
or removing a blockage/obstruction in the grind chamber. Removal of the grind
assembly should be performed by a qualied service technician.
11.5. Cleaning the outside of the grinder
To clean the exterior of the grinder, rst wipe with a dry soft cloth, and then gently
wipe with a damp soapy cloth.
11.6. Cleaning the touch screen
Proper cleaning should be done with a soft, damp microber towel. Preferably
distilled water or other cleaning product specically designed for touch screen
cleaning.
Turn off the grinder and gently wipe off the screen using a circular motion.
12. MAINTENANCE
12.1. General warning
Before performing any type of maintenance you should:
• Always turn OFF the main power switch to the off position ( ).
• If the grinder is jammed, unplug it from the power source and contact an
authorized service technician.
Not following these warnings can compromise the safety of the grinder as well as
the user.
12.2. General maintenance of the grind chamber
To guarantee the efciency and correct operation of the grinder, it is essential to
follow manufacturer instructions and ensure that all maintenance work is carried
out by qualied staff.
Dull burrs will result in; a lower quality grind, greater heat generation in the coffee
and grinder, increased electrical consumption, and nally it puts additional stress on
the grinder motor.