Compak E5 OD - Regulation

K06307 | v. 12/07/2016 | Ref. quality process 002/03 | ORIGINAL INSTRUCTIONS
9
8. REGULATION
8.1. Adjusting the lower portalter support
In order to ensure the proper distribution of ground coffee in the portalter, while
supporting the portalter in a hands-free position during dosing, it is possible to
adjust the height of the lower portalter support ( ).
To do this adjustment operation:
1. Loosen the screw ( ) on the lower support ( ) by using the Allen Key included
with your grinder.
2. Adjust the support to the desired height using the portalter as the point of
reference.
3. Tighten the screw ( ) with the Allen Key provided (Fig. 1).
NOTE: If the adjustment is extreme (too high or too low), difculties in operating the
dosis button might occur.