Compak K3 - Bean Hopper and Grind Chamber Cleaning

K01068 | v. 22/09/2014 | Ref. quality process 002/03 | ORIGINAL INSTRUCTIONS
15
The steps to follow are:
• Inordertoproperlycleanthebeanhopper,rstemptyoutallremainingbeans
and fragments.
• Close the bean trap on the hopper ( ) and grind out the remaining coffee in the
grind chamber.
• Remove any remaining coffee beans from the bean hopper ( ).
• Pour the recommended grinder cleaning product into the bean hopper ( ) and
open the bean trap ( ), allowing the cleaning product to pass into the grind
chamber.
• Grind the cleaning product at a medium course grind setting until the recommended
amount is passed through the system and nothing remains in the grind chamber.
• Clean the hopper ( )andrellwithcoffeebeans.
• Discardtherst2-3dosesofcoffeetoassurethattheresidualcleaningproduct
is removed from the grind chamber and set the grind regulator to the desired
setting ( ).
Following these steps will ensure that the grinder is clean and ready for use.
We do not recommend the taking apart of the grind assembly unless changing burrs,
or removing a blockage/obstruction in the grind chamber. Removal of the grind
assemblyshouldbeperformedbyaqualiedservicetechnician.
10.3.Cleaningdegroundcoffeedeposit
To cleanthe ground coffee holder, rst emptyall the coffee insideit. Removethe
ground coffee dispenser lid ( ) and clean the inside, using a small brush.
10.4.Cleaningtheoutsideofthegrinder
Tocleantheexteriorofthegrinder,rstwipewithadrysoftcloth,andthengently
wipe with a damp soapy cloth.