Compak K3 - Technical Characteristics; Technical Data and Work Cycles

ORIGINAL INSTRUCTIONS | Ref. quality process 002/03 | v. 22/09/2014 | K01068
4
5. TECHNICAL CARACTERISITICS
5.1.Usage
The coffee grinders are intended for use on commercial premises and facilities where
ground coffee is required, or in small stores that sell coffee. The grinder must only be
used to grind coffee beans. Any use other than this will be considered improper and
dangerous.
NOTE: The manufacturer will not be held responsible for any damages resulting from
improper use of the equipment, or for not following the safety measures as outlined
below.
5.2.Technicaldata
Model
100V
50Hz
100V
60Hz
110V
60Hz
220V
60Hz
230V
50Hz
240V
50Hz
400Vψ
50Hz
208V
60Hz
K3,
K3 ELITE
Electric
power
200 200 230 210 210 225
(W)
Spin
speed
1,320 1,620 1,650 1,640 1,340 1,345 rpm
K6,
K6 SILENZIO,
K6 PB
Electric
power
230 230 250 265 240 240 (W)
Spin
speed
1,320 1,600 1,650 1,700 1,395 1,400 rpm
K8
SILENZIO
Electric
power
380 400 440 420 400 440 (W)
Spin
speed
1,300 1,450 1,140 1,600 1,325 1,330 rpm
K10 CONIC,
K10 CONIC
PB
Electric
power
890 960 825 825 800 850 780 840 (W)
Spin
speed
1,340 1,550 1,600 1,500 1,300 1,325 1,400 1,600 rpm
K10 MASTER
CONIC,
K10 MASTER
CONIC PB
Electric
power
850 1,000 935 930 950 975 780 840 (W)
Spin
speed
326 378 325 388 340 345 350 390 rpm