F1 Help
↑↓Select Item
F5/F6 Change Values
F9 Setup Defaults
Esc Exit
← → Select
Screen
Enter Select ▶SubMenu
F10 Save and Exit
Supervisor Password
Show the Password status: Clear or Set
User Password
Show the User Password status: Clear or Set
Set Supervisor/ HDD Password
Install or Change the password.
Power on Password
Enable or disable the Power on Password. You only can enable/disable Power on password
after the Supervisor password is set.
HDD Password Status
This item will show enable or disable HDD Password Status.
Help information
Set Supeivisor Password
Install or change the password and the length of password must be greater than one word and
less then ten words.
User Password
Install or change the password and the length of password must be greater than one word and
less then ten words.
Power on password
Enable:System will ask input password on post time. Disable:System will ask input pass-
To Next Page
Loading...
