Removal and Replacement Procedures 5-31
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: David Calvert Saved by: JAbercrombie Saved date: 04/05/00 1:32 PM
Part Number: 177845-001 File name: CH05.doc
When replacing the display assembly, it is imperative that the DIP
switches are correctly set. To set the display DIP switches on the system
board, follow the steps below.
1. Remove the display assembly.
2. Locate the part number label on the display microphone cable ➊
(Figure 5-28).
3. Part number “441668500001/176038-001” corresponds to the
12.1-inch, TFT display assembly. If this is the part number on the
label, make sure the display DIP switch on the system board is set
according to setting ➋.
4. Part number “441668500002/176037-001” corresponds to the
12.1-inch, HPA display assembly. If this is the part number on the
label, make sure the display DIP switch on the system board is set
according to setting ➌.
Figure 5-28. Setting the Display DIP Switches
5. After the DIP switch settings have been verified, reassemble the
computer.
To Next Page
Loading...
