Compaq 5000 Series - Reconnecting Drive Cables

14 R
EPLACING THE
DVD-RAM D
RIVE
3. Reconnect the power cable
1
11
1,
data cable
2
22
2
, and
audio cable
3
33
3
(if there is one) to the new drive (see
Figure 5-3).
Figure 5-3
Important: The jumpers located on the rear of the DVD-RAM drive must
be set to cable select (CS). If the jumper is not set to cable select, the
computer’s operating system will not recognize the new DVD-RAM drive.
Your DVD-RAM drive jumper
will be factory set for cable
select (CS) before being
shipped.
Did you know ...