Compaq dc5850 - Microtower PC Introduction

9
Manageability Feature Enabling
Manageability features such as DASH and ASF are disabled by default on the Broadcom NetXtreme
Gigabit Ethernet Plus network adapter.
DASH Enabling
DASH can be enabled in one of two methods:
• Broadcom Manageability Configuration and Control application (BMCC)
• Broadcom Advanced Control Suite (BACS)
BMCC is not pre-installed in the system image. It requires the Broadcom NetXtreme Gigabit Drivers for
Multiple Operating Systems Softpaq to be downloaded. BACS is included in the system image.
The following steps will enable DASH with BMCC:
1. Download the Broadcom NetXtreme Gigabit Drivers for Multiple Operating Systems Softpaq from
www.hp.com.
2. Install the Softpaq.
3. Open a Command box as Administrator.
4. Go to the directory where the Broadcom application is installed.
5. Run bmcc enable.
The following steps will enable DASH with BACS:
1. Execute BACs.
2. Choose the Broadcom NetXtreme Gigabit Ethernet Plus network adapter.
Note that all network adapters will be displayed by BACS. The Broadcom NetXtreme Gigabit Ethernet
Plus can be identified through the Information tab. Look for the ASIC and Firmware of 5761.

Compaq dc5850 - Microtower PC Specifications

General

Memory	Up to 8 GB DDR2 SDRAM
Form Factor	Microtower
Audio	Integrated High Definition audio
Power Supply	300W
Processor	AMD Athlon X2, AMD Athlon, AMD Sempron
Storage	SATA 3.0 Gb/s Hard Drives
Graphics	Integrated ATI Radeon 3100 graphics
Optical Drive	DVD-ROM, DVD+/-RW
Operating System	Windows Vista
Expansion Slots	1 PCI Express x16, 2 PCI Express x1
Network	Integrated Gigabit Ethernet
Ports	1 serial, 1 parallel, 1 VGA, 1 RJ-45, audio in/out