Compaq dc5850 - Microtower PC Use Guide

16
• At the prompt, press Ctrl + Y to Modify Array Capacity or press any other key to use maxi-
mum capacity.
•Press Esc to exit and return to the main menu.
5. Press Esc to exit. At system prompt, press Y to reboot or any other key to go back.
Select boot order
To set up your system to boot from the CD, you may need to change the boot order in the F10 setup
menu.
1. Turn on or restart the computer by clicking Start > Shut Down > Restart the Computer.
2. Press F10 as soon as the monitor light turns green.
If you do not press F10 at the appropriate time, you must restart the computer, and then press F10
again to access the utility.
3. Select your language from the list, and then press Enter.
4. Use the arrow keys to select Storage.
5. Use the down arrow key to select Boot Order, and then press Enter.
6. Use the down arrow key to select ATAPI CD-ROM Drive, and then press Enter. Press the arrow key up
to the desired position in the boot order. Press Enter again and F10 to accept the change.
7. To apply and save changes, select File > Save Changes and Exit.
• If you do not want to apply your changes, select Ignore Changes and Exit.
• To reset to factory settings, select Apply Defaults and Exit. This option restores the original
factory defaults.

Compaq dc5850 - Microtower PC Specifications

General

Memory	Up to 8 GB DDR2 SDRAM
Form Factor	Microtower
Audio	Integrated High Definition audio
Power Supply	300W
Processor	AMD Athlon X2, AMD Athlon, AMD Sempron
Storage	SATA 3.0 Gb/s Hard Drives
Graphics	Integrated ATI Radeon 3100 graphics
Optical Drive	DVD-ROM, DVD+/-RW
Operating System	Windows Vista
Expansion Slots	1 PCI Express x16, 2 PCI Express x1
Network	Integrated Gigabit Ethernet
Ports	1 serial, 1 parallel, 1 VGA, 1 RJ-45, audio in/out