Reference Guide
4-5
Writer: Dianne Fielden Saved By: Holly Jahangiri Saved Date: 07/24/97 4:42 PM
Pages: 14 Words: 1776 Template: c:\template\commercial\comm.dot
File Name Ch4.doc Part Number 308336-001
Preparing the
Computer for
Disassembly
To prepare the computer for disassembly, complete the
following steps:
1. Turn off the computer and any devices connected to it.
2. Disconnect the power cord from the electrical outlet and then
from the computer.
3. Disconnect all peripheral device cables from the computer.
✎
During disassembly, label each cable as you remove it,
noting its position and routing. Keep all screws with the
units removed.
Device Installation
Sequence
It is very important that you follow this sequence of steps to
ensure the proper installation of any optional equipment. For
more information about Computer Setup, refer to Chapter 5,
“Using Compaq Utilities.”
1. If the computer is already on, turn it off and disconnect the
power cord from the wall outlet.
!
WARNING:
To reduce the risk of personal injury from electrical
shock and/or hot surfaces, be sure to disconnect the power cord
from the wall outlet, and allow the internal system components to
cool before touching.
!
WARNING:
To reduce the risk of electrical shock, fire, or damage
to the equipment, do not plug telecommunications/telephone
connectors into the network interface controller (NIC) receptacles.
CAUTION:
Static electricity can damage the electronic
components of the computer or optional equipment. Before
beginning these procedures, ensure that you are discharged of
static electricity by briefly touching a grounded metal object. Refer
to Appendix F for more information.
2. Open the computer by removing its outside cover. Refer to
the section “Removing the Cover” in this chapter for
complete instructions.
To Next Page
Loading...
