Compaq.com - Compaq Presario Maintenance and Service Guide - 5200 Series
United States December 10, 2002
Maintenance and Service Guide
Compaq Presario 5000, 5100, and 5200 Series Computers
MSG index Product Description Troubleshooting
Illustrated Parts
Catalog
Home
Removal &
Replacement
Jumper & Switch
Information
Specifications
Models and
features
CPU controls
and lights
Keyboard
controls and
lights
Creativity
Action Center
Rear CPU
connectors
Power cord
set
requirements
l
PRODUCT DESCRIPTION
Power Cord Set Requirements
The power supply needs to be set to 115/230 Volts AC for each country.
The power cord set (flexible cord and wall plug) received with the computer
meets the requirements for use in the country where the computer was
purchased.
Power cord sets for use in other countries must meet the requirements of the
country where you use the computer. For more information on power cord set
requirements, contact your Compaq authorized dealer, reseller, or service
provider.
General Requirements
The requirements listed below are applicable to all countries:
1
The length of the power cord set must be at least 6.00
feet (1.8 m) and a maximum of 9.75 feet (3.0 m).
2
All power cord sets must be approved by an
acceptable accredited agency responsible for
evaluation in the country where the power cord set will
be used.
3
The power cord set must have a minimum current
capacity of 10A and a nominal voltage rating of 125 or
250 volts AC, as required by each country's power
system.
4
The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard Sheet
C13 connector, for mating with appliance inlet on the
Switch Box.
Country-Specific Requirements
Country Accredited Agency
Country Accredited
Agency
Australia EANSW* Italy IMQ*
Austria OVE* Japan JIS***
Belgium CEBC* Norway NEMKO*
Canada CSA** Sweden SEMKO*
Denmark DEMKO* Switzerland SEV*
Finland SETI* United
Kingdom
BSI*
France UTE* United States UL**
Germany VDE*
ll ll
* The flexible cord must be <HAR> Type HO3VV-F, 3-
conductor, 1.0 mm2 conductor size. Power cord set fittings
(appliance coupler and wall plug) must bear the certification
mark of the agency responsible for evaluation in the country
where it will be used.
** The flexible cord must be Type SJT-2 or equivalent, No. 18
AWG, 3-conductor. The wall plug must be a two-pole
grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-
15P (15A, 250V) configuration.
*** The appliance coupler, flexible cord, and wall plug must
bear a "T" mark and registration number in accordance with
the Japanese Dentori Law. Flexible cord must be Type VCT or
VCTF, 3-conductor, 0.75mm2 conductor size. The wall plug
must be a two-pole type with a Japanese Industrial Standard
C8303 (15A, 125V) configuration.
privacy statement
legal notices
http://h18000.www1.hp.com/athome/support/msgs/5000/pwrcrd.html [12/10/2002 9:28:34 AM]
To Next Page
Loading...
