United States
Compaq Presario Internet PC 5000 Series Computers
REMOVAL AND REPLACEMENT PROCEDURES
PRODUCT DESCRIPTION TROUBLESHOOTING ILLUSTRATED PARTS CATALOG
REMOVAL AND REPLACEMENT PROCEDURES
JUMPER AND SWITCH INFORMATION SPECIFICATIONS
ELECTROSTATIC
DISCHARGE
SERVICE
CONSIDERATIONS
PREPARATION FOR
DISASSEMBLY
SERIAL NUMBER
SIDE ACCESS PANEL
GRAPHICS CARD
EXPANSION CARD
(Modem or Network
Card)
1394 CARD
MEMORY MODULE
HARD DRIVE
DISK DRIVE
REMOVING THE TOP
DOOR
REMOVING THE CD
STORAGE DOOR
(Lower Front Panel -
Open the CD Storage
Door)
Removing the 1394 Card, Continued
Removal
Remove the screw securing the 1394 card
.4.
Pull the 1394 card using a gentle side-to-side rocking
motion from the connector on the system board.
5.
Replacement
Important: The 1394 card rear connector must be properly
inserted into the rear chassis slot to ensure the card is properly
seated into the connector on the system board.
Align the card with connector on the system board and rear
connector slots on the chassis.
1.
Reconnect the data cable and the power cable.2.
Replace the screw to secure the 1394 card to the chassis.3.
To Next Page
Loading...
