Compaq Presario 5UV430 - Removing the Expansion Card

United States
Compaq Presario Internet PC 5000 Series Computers
REMOVAL AND REPLACEMENT PROCEDURES
PRODUCT DESCRIPTION TROUBLESHOOTING ILLUSTRATED PARTS CATALOG
REMOVAL AND REPLACEMENT PROCEDURES
JUMPER AND SWITCH INFORMATION SPECIFICATIONS
ELECTROSTATIC
DISCHARGE
SERVICE
CONSIDERATIONS
PREPARATION FOR
DISASSEMBLY
SERIAL NUMBER
SIDE ACCESS PANEL
GRAPHICS CARD
EXPANSION CARD
(Modem or Network
Card)
1394 CARD
MEMORY MODULE
HARD DRIVE
DISK DRIVE
REMOVING THE TOP
DOOR
REMOVING THE CD
STORAGE DOOR
(Lower Front Panel -
Open the CD Storage
Door)
Removing the Expansion Card
Removal
Perform the preparation procedures.1.
Turn the computer on its side (open side facing up)
and locate the expansion card(s).
2.
Remove the screw securing the expansion card.3.
Pull the expansion card using a gentle rocking motion
from the connector on the system board.
4.
Replacement
Important: The expansion card rear connector
must be properly inserted into the rear chassis
slot to ensure the card is properly seated into
the connector on the system board.
Align the card with connector on the system board
and rear connector slots on the chassis.
1.
Replace the screw to secure the expansion card to the
chassis.
2.