United States
Compaq Presario Internet PC 5000 Series Computers
REMOVAL AND REPLACEMENT PROCEDURES
PRODUCT DESCRIPTION TROUBLESHOOTING ILLUSTRATED PARTS CATALOG
REMOVAL AND REPLACEMENT PROCEDURES
JUMPER AND SWITCH INFORMATION SPECIFICATIONS
ELECTROSTATIC
DISCHARGE
SERVICE
CONSIDERATIONS
PREPARATION FOR
DISASSEMBLY
SERIAL NUMBER
SIDE ACCESS PANEL
GRAPHICS CARD
EXPANSION CARD
(Modem or Network
Card)
1394 CARD
MEMORY MODULE
HARD DRIVE
DISK DRIVE
REMOVING THE TOP
DOOR
REMOVING THE CD
STORAGE DOOR
(Lower Front Panel -
Open the CD Storage
Door)
Preparation for Disassembly
To prepare the computer for removal and replacement procedures, complete the following steps:
Remove any disk, compact disc, or tape from the computer.1.
Turn off the computer and any peripheral devices that are connected to the computer.2.
CAUTION
The computer power switch should be turned off before you disconnect any cables.
CAUTION
Before doing any work inside your computer, ground yourself by touching a metal
part of the chassis.
Disconnect the power cord from the electrical outlet, and then from the computer.3.
Disconnect all peripheral device cables from the computer.4.
Turn the computer over on its side (open side facing up).5.
IMPORTANT
During disassembly, label each cable as you remove it. Be sure to note its
position and routing.
To Next Page
Loading...
