Compaq Presario V2000 - Notebook PC User Manual

Getting Started 1–1
1
Hardware Setup
During hardware setup, you will
1. Identify the hardware you need to set up the notebook.
2. Insert the battery pack into the notebook, so the battery
can
begin to charge as soon as the notebook is connected
to
external power.
3. Connect the modem, so you will be able to register the
notebook and operating system during software setup.
4. Connect the notebook to external power.
5. Open the notebook.
6. Turn on the notebook.
When the notebook is turned on, you will be prompted to
begin
software setup.
Ä
CAUTION: To prevent file corruption and ensure that the correct drivers
are installed:
■ Do not set up the notebook for the first time while the notebook is
docked in an optional Expansion Base. (The Expansion Base can
be used only with select models.)
■ During the hardware and software setup procedures:
❏ Do not unplug the notebook from external power.
❏ Do not shut down the notebook or initiate Standby
or Hibernation.
❏ Do connect your modem as instructed in the “Step 3: Connect
the Modem” section later in this chapter, but do not insert,
remove, connect, or disconnect any other device, cable,
or
cord.

Compaq Presario V2000 - Notebook PC Specifications

General

RAM	256 MB to 2 GB DDR SDRAM
Storage	40 GB to 100 GB HDD
Battery	6-cell Lithium-Ion
Processor	Intel Pentium M or Intel Celeron M
Graphics	Intel Graphics Media Accelerator 900
Operating System	Windows XP Home or Windows XP Professional
Optical Drive	DVD±RW
Wireless	802.11b/g
Networking	10/100 Ethernet LAN
Ports	3 x USB 2.0, VGA, RJ-45, headphone, microphone
Display	14.1 inch WXGA (1280 x 768)