8. Remove the display assembly (2).
9.
If it is necessary to replace any of the display assembly internal components, remove the following
screw covers and screws. The display rubber screw covers are included in the Rubber Feet Kit, spare
part number 417096-001.
(1) Six rubber screw covers on the display bezel top edge and bottom edge corners
(2) Two rubber screw covers on the display bezel bottom edge
(3) Eight Phillips PM2.5×7.0 screws
NOTE: There are two different sizes of display bezel rubber screw covers. The thicker covers (2)
must be installed in the bottom center screw holes.
10. Flex the inside edges of the left and right sides (1) and the top and bottom sides (2) of the display
bezel until the bezel disengages from the display enclosure.
Component replacement procedures 73
To Next Page
Loading...
