10. Remove the two Phillips PM2.0×3.0 screws (1) that secure the camera module to the camera module
bracket.
11. Remove the camera module (2) from the bracket.
Reverse this procedure to install the camera module.
Top cover
Description Spare part number
Top cover (includes TouchPad and cable)
For use only in full-featured computer models with Intel processors and a camera module 462524-001
For use in full-featured computer models with Intel processors without a camera module 448620-001
For use in full-featured computer models with AMD processors 455857-001
For use in defeatured computer models with AMD processors 417091-001
For use only in defeatured computer models with Intel processors 460947-001
For use only in defeatured computer models with Intel processors and a card reader 461267-001
Before removing the top cover, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
80 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
