4.
Remove the battery (see
Battery on page 53).
5.
Remove the following components:
a.
Hard drive (see
Hard drive on page 54)
b.
WLAN cover (see
WLAN module on page 57)
c.
Optical drive (see
Optical drive on page 64)
d.
Keyboard (see
Keyboard on page 66)
e.
Switch cover (see
Switch cover on page 69)
f.
Display assembly (see
Display assembly on page 71)
Remove the top cover:
1.
Turn the computer upside down, with the front toward you.
2.
Remove the seven Phillips PM2.5×9.0 screws that secure the top cover to the computer.
3. Remove the two Phillips PM2.0×3.0 screws (1) and the three Phillips PM2.0×5.0 screws (2) that
secure the top cover to the computer.
4.
Turn the computer right-side up, with the front toward you.
Component replacement procedures 81
To Next Page
Loading...
