ENTERING SETTINGS
Press: SET Display will say (1 R xx.x) (Regrind)
or (1 N xxx) (Natural)
or (1 A xx.x) (Additive)
1 is Component number.
R,N,A is Type.
xx.x is Setting.
Enter a 3 digit setting:
Regrind settings = PERCENTAGE of the ENTIRE MIX
Natural settings = RATIO to OTHER NATURAL SETTINGS
Additive settings = PERCENTAGE of ALL the NATURALS
Press: SET for the NEXT setting.
Repeat this sequence for all components.
Press: EXIT when finished.
When entering settings, remember:
Panel front OUTLETS are always components 5 and 6; (left and right).
If only one natural is present, any number will do for a setting.
Any component set to zero will not dispense.
THUMBWHEEL ASSIGNMENTS - THIS IS OPTIONAL
You may assign a component to one of the three thumbwheel switches.
You might do this for components that you wish to change settings
frequently. This is ENTIRELY OPTIONAL.
TO DO SO:
Press: SET Display will say (1 R xx.x)
Press: A Display will say (1 R TW 1) (Thumbwheel 1)
or B Display will say (1 R TW 2) (Thumbwheel 2)
or C Display will say (1 R TW 3) (Thumbwheel 3)
1 = TOP switches,
2 = MIDDLE switches,
3 = BOTTOM switches.
To RETURN component to KEYPAD entry of the setting:
Press: CE Display will return to (1 R 00.0)
Press: EXIT when finished.
Page 20
To Next Page
Loading...
