+---------------------------------------------------------------------+
¦ PART III - PRINTED OUTPUTS ¦
+---------------------------------------------------------------------+
MONITORING SYSTEM ACCURACY
*54 - CYCLE PRINTOUT INFORMATION
The best way to monitor system accuracy is to connect a printer to the
printer port and turn the printer flag ON (KEYPAD section, *54). The
printer will then automatically print full output information after
every cycle.
When the printer flag is ON, the controller will output a single
heading line at the top of each page and 4 information lines to the
printer at the end of each cycle. This adds several seconds to each
cycle time. To turn the printer flag on:
Press: * Display will say: (PASSWORD)
Press: 22222 Display will say: (P x)
Press: *54 Display will say: (PRNT OFF)
Press: * Display will say: (PRNT ON)
Press: EXIT Display will say: (P x)
EXIT Display will say: ( x)
Any common parallel printer that you would use with a small PC computer
may be used. Connect using a standard parallel printer connecting
cable, (34 pin parallel Centronix connector to a DB25 IBM compatible
connector), available from us or at any computer store.
INTERPRETING the *54 CYCLE PRINTOUT
10 or 20 cycles of data can tell a lot about the performance of your
blender. The following will help you interpret the data.
A single cycle printout looks like this:
(dashes ---- added for clarity of spacing)
------------ ------------ ------------ ------------ ------
**1 R 20.0** **2 N 100** **3 A 04.0** **4 A 00.0** TOTAL
* 11/10/97 * * 16:17:53 * RECIPE 0000 **ID# 051** **WO 000000* OPR000
FINAL: DISP,% 0.0 .0 1908.3 77.6 4.06 0.0 .00 2000.1
RATE: GR/TIME 18224 976 19993 488 12973 31232 10240 31232 9.9
1ST DISP,TIME 0.0 00 1908.3 469 77.6 1826 0.0 00 22
DEFINITION OF EACH LINE
The TOP-OF-PAGE heading:
------------ ------------ ------------ ------------ ------
**1 R 20.0** **2 N 100** **3 A 04.0** **4 A 00.0** TOTAL
Prints as a heading to each page, or once every 10 cycles. This serves
as a heading over four columns of material. Additional lines will
Page 74
To Next Page
Loading...
