SAFETY HAZARDS
+-----------------------------------------------------------+
¦ MIX BLADES ¦
¦ ¦
¦ Mix blades are driven with substantial torque. ¦
¦ ¦
¦ NEVER place your hand in the mix chamber ¦
¦ while blades are turning. ¦
¦ ¦
¦ SERIOUS INJURY will result. ¦
+-----------------------------------------------------------+
+-----------------------------------------------------------+
¦ ADDITIONAL MIX BLADE HAZARD ¦
¦ ¦
¦ Over time, mix blades may become RAZOR SHARP. ¦
¦ ¦
¦ Always be careful when TOUCHING or CLEANING these blades. ¦
¦ Check for sharp edges frequently. ¦
¦ Replace blade if a hazard exists. ¦
+-----------------------------------------------------------+
+-----------------------------------------------------------+
¦ SLIDE VALVES ¦
¦ ¦
¦ Slide valves in hoppers SLAM CLOSED without warning. ¦
¦ They WILL injure your fingers. ¦
¦ ¦
¦ ALWAYS keep fingers clear of slide gate openings. ¦
¦ NEVER use your fingers to clear an obstruction. ¦
¦ NEVER use your fingers to move a sticking slide gate. ¦
+-----------------------------------------------------------+
SAFETY FEATURES
+-----------------------------------------------------------+
¦ SAFETY INTERLOCK SWITCH ¦
¦ ¦
¦ The ACCESS DOOR is equipped with a safety interlock ¦
¦ switch that prevents the mix motor from running and ¦
¦ the slide valves from opening. ¦
¦ ¦
¦ DO NOT defeat this safety switch. ¦
+-----------------------------------------------------------+
+-----------------------------------------------------------+
¦ HOPPER FINGER GUARDS ¦
¦ ¦
¦ Finger guards are fitted into each hopper compartment. ¦
¦ DO NOT reach through these guards. ¦
¦ DO NOT use your fingers to clear an ¦
¦ obstruction below these guards. ¦
¦ ¦
¦ DO NOT remove these guards. ¦
+-----------------------------------------------------------+
+---------------------------------------------+
¦ PROCEED TO: ASSEMBLY NEXT PAGE ¦
+---------------------------------------------+
Part 4
To Next Page
Loading...
