Concept2 SkiErg Replacement Guide

Page 1 1014
concept2.com/ski
Replacing SkiErg Handles
Procedure
Note: This procedure will be easiest if there is
slack on the handle cords during replacement.
1. Using a flathead screwdriver, pry the handle
plug from the handle.
See photos A and B.
2. Remove the handle cord from the plug and
handle.
See photos C and D.
3. Using the 6-lobe driver from your SkiErg
assembly packet, insert the handle cord into
the replacement handle and push it through
with the driver. Note that the replacement
handles DO NOT have black lines on them.
See photos E and F.
A
B
C
D
E
F
Materials Needed
• Handlesandhandleplugs
• Flatheadscrewdriver
• 6-lobedriver
Procedure Overview
• Removehandleplugsandremovethehandlecords
• Inserthandlecordsinreplacementhandles
• Attachhandlecordstohandleplugsandpressintohandle

Concept2 SkiErg Specifications

General

Resistance Type	Air resistance
Monitor	PM5
Drive Mechanism	High-strength cords
Power Requirements	2 D cell batteries
Maximum User Weight	227 kg (500 lb)
Construction	Steel and aluminum
Storage	Can be stored upright
Display Metrics	Time, distance, pace, calories, watts, stroke rate
Space Recommended for Use	61 cm x 122 cm (24 in x 48 in)
Warranty	2-year limited warranty