Conlan CT1000 - Advanced Configurations; Service Code; Configuration Overview; Changing the Master Code

5
4. Advanced settings
4.1 Service Code
The Service Code is used for CT1000’s advanced settings such as changing the Master Code
and Service Code, LED indication and much more. The overview of the settings and the facto-
ry settings can be seen in 4.2 Conguration Overview.
The Service Code is 12347890 (factory default).
Note:BeforetheServiceCodecanbeusedthevoltagemustbeturnedoandon(theSer-
vice Code can no.
After entering the Service Code the reader is in programming mode (the green LED lit).
Eachtimeasettingismade,theCT1000goesbacktothepreviouspointandthenextsetting
canbemade.Thenavigationisbyenteringthecongurationnumberand#
4.2CongurationOverview
Cong. no. Setting Default
00 Master Code (1 to 8 digits) 4711
01 Service Code (1 to 8 digits) 12347890
02 LED indication 31
03 Outputtime(white) 5
04 Outputtime(yellow) 5 (for codes)
05 Function settings 0
06 Activationwithcodes/bell 29
2500 All codes on position 1 to 28 is deleted
0250 Reset to factory default
4.3 Changing the Master Code
ByfactoryistheMasterCode4711 and can only be used to program, change or delete users
on the CT1000.
To change the Master Code, enter the following:
○ ● ○ ● ● ○ ○ ● ○
#
Key in the
Service Code
#
Key in
00
#
Key in a new
code