Conlan CT1000 - Function Settings; Activating the Output with Codes;Bell

7
4.7 Function Settings
These settings is used to change CT1000’s function e.g. to use the Service Code without pow-
er down and up, mute the buzzer etc.
Theoverviewbelowshowsthevaluesforthedierentfunctions.
On O
Buzzer 0 1
Toggle mode for 8 digits codes 2 0
ServiceCodewithpoweron/o 4 0
Output(yellowwire)inverted 8 0
Hold function 16 0
Lock L2H 32 0
Lock H2L 64 0
4 digits code without # (rolling code) 128 0
Put the desired values together and enter them in “Key in value”.
To change the function settings, enter the following:
○ ● ○ ● ● ○ ○ ● ○
4.8ActivatingtheOutputwithCodes/Bell
This function is by default set that all codes activate the yellow output and the bell key acti-
vates the white output (value = 29). If the white output also should activate by codes key in 1
to 27 as value, it is the position after the entered value that starts to activate the white out-
put.
To change theses settings, enter the following:
○ ● ○ ● ● ○ ○ ● ○
It is the position after the entered value that starts to activate the white output.
#
Key in the
Service Code
#
Key in
05
#
Key in value
#
Key in the
Service Code
#
Key in
06
#
Key in value
1 to 27