Turning the power on /off
Rotate the power switch/volume control clockwise to turn the power on.
Rotate the power switch/volume control counter-clockwise to turn the power
off.
Note: If you activate “power on password” function via programming software,
each time you turn on radio, the 6 digit password must be entered. If you enter
the wrong password, the radio will restart automatically and you must enter
password again. If you enter the wrong password three times in a row, you
brick the radio and you must reprogram the radio to use it again. Please
enable power on password with due care.
Adjusting the volume
After the radio is powered on, you can rotate the power switch/volume control to
adjust the volume level. Rotate the knob clockwise to increase the volume or
rotate the knob counter-clockwise to decrease the volume.
Selecting a Channel
Turn the channel selector knob to select channel 1 to 16. Rotate the knob
clockwise to increase the channel number, or rotate the knob counter-clockwise
to decrease the channel number. If enabled, the radio channel number will be
audibly annunciated when you change the channel.
Note: If a channel is not programmed, the display says：”Unprogrammed Channel”, there
is an audible message saying “No Channel” and the LED indicator flashes red.
Selecting a Zone
The radio supports up to 64 zones each with a maximum of 16 channels. With all
zones used up to 1024 channels can be used. You may select a desired zone
through “zone” menu or setting “zone toggle” selection function to button 1 or
button 2. To select the zone, use the “Selection Key” to scrolling through the
zones and then when the proper zone is highlighted, press the “OK” key. If voice
enabled, the current radio channel number will be audibly annunciated when you
change the zone.
Call
Each digital channel may assign a contact and the assigned contact could be a
private call contact, a group call contact or an all call contact. To transmit on analog
channels, press and hold down the PTT key, wait for the LED indication to glow red
and then speak 3 to 4 centimeters away from the microphone.
To Next Page
Loading...