Button setting
You may program button1 and button2 for special functions as defined below. Each
key can be defined separately for differently functions depending on if you give the
key a short press or a long press.
This key is not assigned with any function
Allow user to initiate digital group call, digital private call,
call alert or send preset message via the one touch call
function.
You can manually input the private call number for calling.
Allow user to make an emergency call.
Enables and disables the monitor function
This function allows the user to have the backlight on
continuously or only on for five seconds after a key has
been pressed
Allows user to enable the keypad lock feature. If the
keypad lock is enabled user can only operate the PTT
key and side button. Press MENU and # key to
unlock.
Allow user to enable or disable the scan function.
Allow user to enable or disable all alert tones
Indicates battery charge left
Allows you to enter the message function menu
Allows you to enter the zone selection function
Selects between the Analog and Digital Modes
Allow you to enter the Contacts menu
Sends an enable command to a private call contact.
Sends a disable command to a private call contact.
Sends a device check command to a private call contact
Allows you to remotely monitor another radio
Allows user to switch between high and low power
Allows radio to communicate through a repeater or speak
directly to another radio without a repeater.
Enables and disables the VOX function
While scanning, allows you to remove a channel from the
scan list.
Enables and disables the monitor function. Only works
with a long key press
To Next Page
Loading...