• L´afficheur montre ensuite « Sync » et « 120 ».
Le régulateur de chauffage compte à rebours au rythme des secondes et
se trouve, à l´issue des 120 secondes, en mode de service normal.
☞
Pendant ce temps, aucune commande du régulateur de chauffage
n'est possible. Le régulateur de chauffage se synchronise mainte-
nant avec les moteurs pour vannes.
• Faites coulisser le régulateur de chauffage par le
haut jusqu'à ce qu'il s'enclenche sur la fixation
murale, voir filg 8.
116
Figure 8
d) Setting the safety code ("CodE")
To protect the heating control against interference from other radio systems
the device uses a safety code consisting of two parts.
Each part of the code comprises 100 setting options. This means that there
are 10,000 different safety codes available.
☞
To ensure communication between the "FHT8R" heating control
and the "FHT8V" valve operating mechanism/s the same safety
code has to be set for all devices in a room.
This is particularly important if more than one valve operating
mechanism is used or if different devices (i.e. not a set consisting
of heating control and valve operating mechanism) were purcha-
sed.
Proceed as follows to change or set the code:
• Press the "PROG" key until "Sond" is displayed.
• Use the selection wheel to select the special function "CodE".
• To confirm your selection, briefly press the "PROG" key.
The following data are displayed:
• Use the selection wheel to select the first part of the code (a number bet-
ween "000" and "099") and confirm this selection by briefly pressing the
"PROG" key.
To Next Page
Loading...