Conrad SL1007 - Field Setup and Mounting; Getting Started Tips

25
Setting up the camera in the field:
Once all program settings have been setup properly, your
HUNTING CAMERA is ready for field use.
Getting started
Listed below are some helpful pointers on how to use your
camera to get the best results.
• Mount the camera about 1.5~2M (5~6 feet) high with the
camera pointed at a slight downward angle.
• Mount the camera facing north or south NOT east or west
due to the rising and setting of the sun could produce
false triggers and overexposed images.
• If you’re covering a trail, face the camera down or up the
trail. Most commercial cameras take one seconds to
sense motion/heat and take a picture.
• Clear out any brush or weeds in front of camera. This will
cause false pictures caused wind or high temperature
days.
• Double check battery before turning on the camera for
use.
• Make sure to insert the memory card after setting up the
camera.
• Make sure to turn the camera to CAM or PSET mode (or
take out of Test Mode) before you leave.
• Verify time and date is correct.