16
CS624 Qseal-extra Operator´s manual
2.2 Environmental Requirements
To keep the instrument operating at its best, please observe the following:
• The instrument should be placed on a at surface free from dust, solvents and acidic
vapor.
• Use the instrument in an area free from vibration and with a room temperature of
15 - 35°C (60 - 95°F), and relative humidity 10% - 90%.
• Handle the components with care in a clean environment.
2.3 Installation Procedure
2.3.1 Preparing the sealer for use
1. Connect the coaxial cable to the connector on the Hand unit, and the other end
to the front of the Main unit, make sure that both ends are rmly connected.
2. Check that the indicator LED lights up green when the power switch is turned on.
If the LED does not light up check that the battery is correctly inserted and charged.
3. Perform a test seal on an empty or water lled tube to ensure proper operation.
Caution! Ensure that all cables are connected before turning the power on.
To Next Page
Loading...