20
CS624 Qseal-extra Operator´s manual
4. Operating Instructions
This chapter describes the use of the instrument.
Warning! RF energy during seal procedure and movement of electrode.
Warning! Qseal-extra uses radio frequency (RF) energy to generate heat for sealing.
Users should be cautious of potential electrical shocks or hazards while hand-
ling this sealer. Always keep your ngers away from the electrodes in the slot.
Never place any object other than the PVC tube between the electrodes.
Warning! Do not perform a seal within 8 cm (3 in) of needle to preclude an RF burn at
the needle entry point.
Caution! Inspect all parts of the instrument for defects before use. Check sealing
pattern if hand unit is dropped.
Clean electrodes are essential to achieve a good sealing result. Inspect the
electrodes regularly and clean when needed to ensure proper function.
4.1 Preparation before Use
1. Place the instrument on a at surface near the working place. Ensure that it is
placed so the front of the unit is visible during seal procedure.
2. Connect the cables according to chapter 2.3 ”Installation procedure”.
3. Check that the indicator LED lights up green when the power switch is tur-
ned on, otherwise charge the battery, see 2.3.2.
To Next Page
Loading...