22
CS624 Qseal-extra Operator´s manual
4.3 If the Sealer Doesn´t Start
The Sealer has several safety functions. Before sealing, these functions control and iden-
tify whether it is possible to seal the tube. The table below covers the common probable
causes for problems and suggests some recommended actions.
Probable cause Recommended action
Wet tube Dry the tube and try again
Tiny arcs between the electrodes Dry the electrodes and try again
Wet or dirty electrodes Clean and dry the electrodes
If the sealer still doesn’t start, see chapter 6 for further information.
Caution! In case of sealer malfunction (intermittent operation, poor seal quality, the sea-
ling time seems too long or too short) contact your local Conroy Medical
representative for assistance.
Caution! Periodically check the pattern of the sealing visually (see picture below).
Good sealing pattern Bad sealing pattern
To Next Page
Loading...