Conroy Qseal-extra - Head Unit

26
CS624 Qseal-extra Operator´s manual
Problem Probable cause Recommended action
The sealing
doesn’t start.
Wet or dirty electrodes. Dry/clean the electrodes, see chapter 5.2
No connection. Check coaxial cable connections.
Coaxial cable broken. Change coaxial cable.
Other cause. Contact your local C.M. representative.
Incomplete sealing. Low voltage. Check battery charge level.
Other cause. Contact your local C.M. representative.
Intermittent sealing Coaxial cable broken. Change coaxial cable or contact your local
C.M. representative.
Seal lamp
doesn’t light.
Hand unit inoperative. Contact your local C.M. representative.
Coaxial cable broken. Contact your local C.M. representative.
Seal lamp ickers. Coaxial cable broken. Change coaxial cable or contact your local
C.M. representative.
Seal lamp doesn’t
light but electrode
moves.
Main unit inoperative. Contact your local C.M. representative.
6.2 Hand Unit