Medical Test Supply www.medicaltestsupply.com
Warning
◎
Check if the sensor cable is in normal condition before monitoring. After unplugging the
SpO
2
probe cable from the socket, the interface will return.
◎
Do not use the SpO
2
probe once the package or the sensor is found damaged. Instead, you
shall return it to the vendor.
◎
Prolonged and continuous monitoring may increase jeopardy of unexpected change of dermal
condition such as abnormal sensitivity, erubescence, vesicle, repressive putrescence, Particularly
in newborns or in a Perfusion disorders and changes or immature skin form of the patient.
According to skin quality change, correct optical path alignment and attachment methods to
regularly check the place of SpO
2
probe, and change the attachment position when the quality of
skin decline. More frequent examinations may be required for different patients.
Chapter14 Monitoring Procedure
1. Attach the sensor to the appropriate site of the patient finger as shown below.
SpO
2
Placement
2.
Plug the connector of the SpO
2
probe cable into the USB socket in the lower right of the device.
The main interface will switch to SpO
2
interface. The update period of data is less than 5 seconds,
which is changeable according to different individual pulse rate. This operation brings no
affection to other functions.
Warning
Uncomfortable or painful feeling may appear if using the device ceaselessly, especially, for
the microcirculation barrier patients. It is recommended that the sensor should not be
applied to the same finger for over 2 hours.
To Next Page
Loading...
Need help?
General
