6
6
6
6
6 .3
.3
.3
.3 Mounting
Mounting
Mounting
Mounting the
the
the
the hanging
hanging
hanging
hanging rope
rope
rope
rope
Step 1. Put the end of the rope through the hole.
Step 2. Put another end of the rope through the first one and then tighten it.
Figure 4. M ounting the hanging rope
7
7
7
7 Operating
Operating
Operating
Operating Guide
Guide
Guide
Guide
7.1 Insert the two batteries properly to the direction, and then replace the cover.
7.2 O pen the clip as shown
in
Figure 5.
Figure 5. P ut finger
in
position
7.3
L
et the patient
’
s finger put into the rubber cushions of the clip (make sure the finger is
in
the
right position), and then clip the finger.
7.4 Press the switch button once on front panel.
7.5 D o not shake the finger and keep the patient at ease during the process. Meanwhile, human
body is not recommended
in
movement status.
7.6 Get the information directly from screen display.
Fingernails
Fingernails
Fingernails
Fingernails and
and
and
and the
the
the
the luminescent
luminescent
luminescent
luminescent tube
tube
tube
tube should
should
should
should be
be
be
be on
on
on
on the
the
the
the same
same
same
same side.
side.
side.
side.
8
8
8
8 Repairing
Repairing
Repairing
Repairing and
and
and
and Maintenance
Maintenance
Maintenance
Maintenance
Please change the batteries when the low-voltage displayed on the screen .
Please clean the surface of the device before using. Wip e the device with medical alcohol first,
and then
let
it
dry
in
air or clean
it
by dry clean fabric .
Using the medical alcohol to disinfect the product after use, prevent from cross infection for
next time use.
To Next Page
Loading...
Need help?
General
