6 BIOS Setup
60
SIS-8601-LVA
Video Off Method
This determines the manner in which the monitor is blanked
Blank Screen This option only writes blanks to the video
buffer.
V/H SYNC+Blank This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
DPMS Support Select this option if your monitor supports the
Display Power Management Signaling
(DPMS) standard of the Video Electronics
Standards to select video power management
values.
Modem Use IRQ
If system want to restart the computer after a modem call, this option allows you to specify the
IRQ modem so that it can be monitored while waiting for the call.
The Choice: NA , 3, 4, 5, 7, 9, 10, 11
Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state
when the system has Hung.
The choice:
Delay 4 Sec Allows the Power button to place the system in sleep mode and
to wake it up. Holding down the button for at least four seconds
turn off the power supply.
Instant-Off Uses the Power button as a normal system powe ON/OFF button.
State After Power Failure
Selects the type of activation to be performed when the system is turned on back after power
shutdown or failure.
The choice:
Auto Places the system in the shutdown state.
On Always turns on the system.
Off Always turns off the system.
Note that, if you recycle the power supply while it has not been completely shut down, the
system may not be turned on even with this item set to [On].
To Next Page
Loading...