CHAPTER 2 –Ha
r
dwa
r
e
I
n
s
tallatio
n
s
SPI-6941-LV 9
C
h
a
p
t
e
r
2
H
a
r
dw
a
r
e
In
s
t
a
ll
a
t
ion
s
This chapter provides information on how to use the jumpers and connectors on the
SPI-6941-LV in order to set up a workable system.
2
.
1
In
s
t
a
ll
a
t
ion p
r
o
ce
du
r
e
2.1.1 Install the processor with correct orientation.
2.1.2 Insert the DRAM module with correct orientation.
2.1.3 Mount the Fan on the top of the processor and connect it to FAN connector.
2.1.4 Insert all external cables except for flat panel. (Hard disk, floppy, keyboard,
Mouse, LAN, etc.)
2.1.5 Prepare a CRT monitor for CMOS setup.
2.1.6 Confirm CPU card to backplane.
2.1.7 Turn on the power.
2.1.8 Enter the BIOS setup mode by pressing ‘Del’ key during boot up.
2.1.9 Use the “Load BIOS Optimal Defaults” feature.
2.1.10 Configure the Pe
r
ip
h
e
r
al
S
et
u
p and the
S
ta
n
da
r
d
S
et
u
p correctly.
N
ote
:
T
he C
M
O
S
m
e
m
o
r
y
m
ay be in an undefined
s
tate at powe
r
-
on afte
r
a pe
r
iod of no
batte
r
y backup.
Plea
s
e change following B
I
O
S
s
etting befo
r
e in
s
talling
O
S in the ca
s
e that thi
s
boa
r
d i
s
u
s
ed with the
s
y
s
te
m
of the A
T
X powe
r
s
upply.
1. Advanced Chipset Features /Power-Supply Type: [ATX]
2. Power Management Setup /ACPI Functions : [Enabled]
To Next Page
Loading...