CHAPTER 6 – B
I
O
S
S
et
u
p
SPI-6941-LV 67
Invalid system disk Replace the disk, and then press any key
This error occurs when the FDD has been set incorrectly or when the inserted disk is not a
system disk. Check the disk media type. Run the Setup Utility to check whether Drive A/B has
been set correctly and whether the connected drive matches the drive setting.
F
l
opp
y
d
i
sk
(
s
)
f
a
il
(
40
)
A possible cause is no FDD drive connected. Check the FDD cable. If your system has no FDD
connected, use the Setup Utility to set “Drive A” to [None] or “Halt On” to an option that
prevents the system from detecting FDD errors.
K
e
y
boa
r
d
e
rr
o
r
o
r
no
k
e
y
boa
r
d
p
r
e
s
en
t
A possible cause is a defective keyboard or no keyboard connected. If your system has no
keyboard connected, use the Setup Utility to set “Halt On” to an option that prevents the system
from detecting keyboard errors.
I/O
CH
A
N
E
LL
CH
E
C
K
–
CH
E
C
KI
N
G FO
R
SEG
M
E
N
T….
OFFENDING SEGMENT:
XXXX
PRESS F1 TO DISABLE NMI, F2 TO REBOOT
A nonmaskable interrupt (NMI) caused by an active IOCHK signal has occurred. The
prompted action to press the <F1> or <F2> key will not be processed.
R
A
M
PA
R
ITY E
RR
O
R
–
CH
E
C
KI
N
G FO
R
SEG
M
E
N
T….
OFFENDING SEGMENT:
XXXX
PRESS F1 TO DISABLE NMI, F2 TO REBOOT
An NMI caused by a parity error has occurred. The prompted action to press the <F1> or <F2>
key will not be processed.
To Next Page
Loading...