Edition 05/2021 - COMPACT - technical documentation - page 10
SACOME, CONFIDENTIAL Document, it is forbidden to duplicate or communicate this document without previous authorization.
8. RELATED FONCTIONS
8.1. ECO MODE SETTING
The evening or before a long period of inactivity, the economic development mode of the machine allows
the standby position.
The boiler is then maintained at a temperature of 60°C, which allows:
• saving energy when the temperature drop
• and during the day, the setpoint temperature maintenance is low, this phase mobilizes little energy.
To activate the "ECO" mode, proceed as follows:
• hold the "P5 Gr1" key,
• and press "P3 Gr1"
• all lights will turn off to indicate the change in "ECO" mode,
• LEDs and "L1 Gr1" blinks slowly (0.2 sec ON / OFF 2.8 sec).
The output of "ECO" mode allows the machine to return quickly to its mode of operation, without large
expenditures of energy.
To return to normal operation, proceed as follows:
• Press the button "P3 Gr1".
• All the LEDs light up to indicate the return to normal operation.
• The machine will heat up to reach the programmed temperature.
8.2. AUTOMATIC CLEANNING OF COFFEE GROUP
The cleaning of coffee group is made group by group, preferably at the end of service, before the machine is
stopped or put in "ECO" mode, using this specific function managed by the machine.
The procedure for cleaning coffee groups is as follows:
• Remove the filter-holder from the group and clean the seal with the supplied brush.
• Insert blind filter (provided with the machine) in the filter-holder.
• Put a detergent tablet (CONTI brand code: 466662) in the blind filter, and engage the filter-holder in
the group.
• Keep pressing key n°5 (P5 Gr1), then press the key n°1 (P1 Gr1).
• The cleaning process starts automatically, with somes ON/OFF cycles. The purpose is to disolve the
tablet, and release the cleaning agent on the coffee group circuit and on the coffee valve.
• When the cleaning cycle is finished, and the group is available again.
• Repeat this operating mode on each group.
The cleaning cycle can be interrupted, pushing any key of the concerned group. But, you will lost the
following steps, and will compromise the cleaning efficiency.
It is possible to perform an automatic washing cycle for each group independently
8.3. RESETTING DATA
If necessary, it is possible to re-configure the machine with data by default.
The procedure is as follows:
• Turn off the power supply of the machine.
• Keep pressing simultaneously the keys “P1 Gr1” + “P3 Gr1”+”P5 Gr1”
• Turn the machine on.
• When led n°1, n°3 and n°5 are lighting, release the button
To return to normal operation, turn off and on the machine.
To Next Page
Loading...
