www.rinnai.us
Model V2532W10
BASIC OPERATION
To operate the Continuum V2532W
simply turn any hot water tap on. This
will automatically light the burner
providing hot water at the preset
temperature. If the optional remote
controls have been installed, the “IN
USE” indicator will glow on all remote
controls.
Note: The Rinnai water heater will not
provide hot water instantly at the hot
water fixtures. Any cold water existing in
the hot water lines must be purged first.
Adjusting Temperature
1
To take control of the Continuum V2532W
all hot water taps must be closed. Press
the "Priority button" on the controller you
want to set the temperature with. The
"Priority" indicator light will glow and the
“Set Temperature” display will show the
last temperature setpoint for this
controller, or the factory setting of 108°F.
The outlet water temperature of the water
heater is adjusted using the Remote
Control thermostats. The temperature can
only be adjusted on the Remote Control
which has the Priority indicator light
glowing. The temperature displayed on
this remote control will also be displayed
on all other Remote Controls.
3
Simply press the
or button until the
required temperature is displayed on the
Digital Monitor. There is a hot water scald
potential if the thermostat is set to high.
4
2
This indicates that the Continuum V2532W
is ready to supply hot water at the set
temperature displayed as soon as a tap is
opened.
To Next Page
Loading...
Need help?
General